(UPS) SYSTEM ELECTRICAL

UNNINTERRUPTIBLE POWER SUPPLY (UPS) SYSTEM ELECTRICAL

27 – 29 April, 22 – 24 Juni 2016 l 08.00-16.00 WIB
Hotel Golden Flower (Bandung)
Hotel The 1O1 (Yogyakarta)
Hotel IBIS (Kuta Bali)
Hotel Senggidi (Lombok)
Hotel Santika (Malang)

DESCRIPTION

This technical course begins with a discussion of the need for UPS systems. It then covers the relative comparisons between various UPS topologies and their modes of operation. The batteries used for UPS systems are covered next. How a battery works, their maintenance, safety and testing is throughly discussed.

UPS System Electrical

UPS System Electrical

A solid working knowledge of the typical electrical components found within a UPS is developed before exploring how AC is converted to DC and then inverting DC back to AC. When all of the above elements of a UPS are understood, a theoretical rectifier and inverter feedback loop are throughly discussed. This will be followed by a trouble shooting exercise. Students are given failure scenarios where they work in groups to find which circuit component has opened, shorted or significantly changed in value to produce the alarm condition described. The course finishes with a general discussion on UPS system trouble shooting.

Some working knowledge of basic electrical engineering principles is required, although this will be revised at the beginning of the course. Real-life experience in working with batteries and UPS systems will enable the workshop to be placed in context.

WHO SHOULD ATTEND

This course is recommended for:

  • Electrical Engineers
  • Electrical Maintenance Tradespeople & Technicians
  • Instrumentation and Control Engineers
  • Power System Protection and Control Engineers
  • Building Service Designers
  • Data Systems Planners and Managers
  • Other electrical personnel involved in the maintenance industrial, commericial and institutional power systems.

COURSE CONTENT
1.    Introduction to UPS Systems
    Power conditioners
    Uninterruptible power systems
    Power quality source alternatives
    Power disturbance cost comparisons
2.    Three General Types of UPS’s
    Kinetic (Motor Generator Sets)
    Flywheel
    Static and Components
    Rectifier
    Batteries
    Inverter
3.    Three types of Static UPS’s
    Traditional UPS
    Static UPS
    Static UPS with Bypass
4.    UPS Operation Overview
    The Need for UPS System
    Power System Disturbances
    Basic Type of UPS Systems
5.    Introduction to Batteries
    Primary Batteries
    Secondary Batteries
6.    Lead Acid Batteries
    Chemistry
    Different types
    Capacity Factors
    S-Curves
    Battery Safety and Maintenance
    Float and Equalize Voltages
    Load Testing
7.    Nickel Cadmium Batteries
    Chemistry
    Battery Types
    Capacity Factors
    Battery Safety and Maintenance
    Float and Equalize Voltages
    Load Testing
8.    Passive Electronic Components
    Resistors Circuits
    Capacitor Circuits
    Inductor Circuits
9.    Semiconductors
    Diodes
    SCR’s
    Transistors
10.    Logic Gates
    AND/NAND Gates
    OR/NOR Gates
    Inverter Gate
    D Type Flip Flop
    XOR/XNOR Gates
11.     Operational Amplifiers
    Inverting Op Amp
    Non-inverting Op Amp
    Differential Op Amp
    Unity Gain Op Amp
    Summing Op Amp
    Integrating Op Amp
    Comparator Op Amp
12.    AC to DC Conversion
    Full Bridge
    Three Phase
    Six Pulse
13.    DC to AC Inversion
    Quasi Square wave
    PWM waveform
14.    UPS System Overview
    Rectifier Stage
    Inverter Stage
15.    UPS System Troubleshooting
    Basic Use of Test Equipment
    Rectifier Troubleshooting
    Inverter Troubleshooting

METHOD

Presentation, Discussion, Case Study, Evaluation

FACILITIES

1. Certificate
2. Training Module (Hard and Soft copy (USB Flash Disk)
3. Stationeries: NoteBook and Ballpoint
4. Souvenir (Jacket or waistcoat or T-Shirt)
5. Bag or backpackers
6. Training Photo
7. Training room with full AC facilities and multimedia
8. Once lunch and twice coffeebreak every day of training
9. Qualified instructor
10.Transportation for participants from hotel of participants to/from hotel of training

INFORMATION & REGISTRATION

EVIOPLUS CONSULTANT
Jl.Anggun Utara Blok P-25, Graha Estetika
Pedalangan, Banyumanik – Semarang
Phone : 024-70196308 / 088218661644 (CDMA)
Email  : evioplus@yahoo.com
: yopi@evioplus.com
In House Training: Depend on request
Yopi : 085 225 899 555
Pin BB: 5B038F39

Tinggalkan Balasan

Alamat email Anda tidak akan dipublikasikan. Ruas yang wajib ditandai *